Antenna RX

Sets the RX value for Reader sensitivity. Note that most readers only support base RX a value of ‘1’ or '0'. Impinj supports a variable RX scale to weaken the sensitivity. Note: When a new reader profile is created, TagNet will default the highest TX setting for that Reader Make/Model

Antenna TX

Sets the TX value for Reader Transmit power. Each Reader platform has its own TX scale set by the Reader Manufacturer. For example Zebra uses 1-200, Impinj uses 1-81 and Honeywell uses 1-29. Note: When a new reader profile is created, TagNet will default the default RX setting for that Reader Make/Model.

Antenna Hop Table ID

Specifies the Hop table value for a given reader, the correct value will be defaulted when selecting the Manufacturer / Model

Antenna Channel Index

Specifies the Channel index value for a given reader, the correct value will be defaulted when selecting the Manufacturer / Model

Singulation Control Session

Selectable values of S0,S1,S2,S3. Refer to the Session Control Overview Topic for details.

Tag Population

The estimated tag population that the reader will see in a given read cycle. This helps some readers better manage the singulation protocol.

Tag Inventory Filter

Enables a method to filter out a single Tag ID (no wildcards) at the reader level. This is an experimental feature at this point.

Antenna Stop Trigger

This parameter is only applicable for Zebra FX7500/FX9600 Readers. It specifies the the stop trigger when cycling through the antennas. The allowable values are [Dwell Time] and [Number Inventory Cycles]. This feature is strongly recommended to be used as the default value stop trigger is approx. 1 second. See associated Antenna Stop Condition value below to complete this configuration.

Antenna Stop Condition

This parameter is only applicable for Zebra FX7500/FX9600 Readers. It specifies the the stop condition when cycling through the antennas. When using [Dwell Time] this value is in milliseconds. When using [Number Inventory Cycles] this is a number such as 2, 4, 10, etc. . Note: when using a long dwell time per antenna, this will result in reduced reads for fast moving tags through the RF field.  A recommended starting point is to use (4) Inventory cycles per antenna and then adjust from there.

Antenna RX

Sets the RX value for Reader sensitivity. Note that most readers only support base RX a value of ‘1’ or '0'. Impinj supports a variable RX scale to weaken the sensitivity. Note: When a new reader profile is created, TagNet will default the highest TX setting for that Reader Make/Model

Antenna TX

Sets the TX value for Reader Transmit power. Each Reader platform has its own TX scale set by the Reader Manufacturer. For example Zebra uses 1-200, Impinj uses 1-81 and Honeywell uses 1-29. Note: When a new reader profile is created, TagNet will default the default RX setting for that Reader Make/Model.

Antenna Stop Trigger

This parameter is only applicable for Zebra FX7500/FX9600 Readers. It specifies the the stop trigger when cycling through the antennas. The allowable values are [Dwell Time] and [Number Inventory Cycles]. This feature is strongly recommended to be used as the default value stop trigger is approx. 1 second. See associated Antenna Stop Condition value below to complete this configuration.

Antenna Stop Condition

This parameter is only applicable for Zebra FX7500/FX9600 Readers. It specifies the the stop condition when cycling through the antennas. When using [Dwell Time] this value is in milliseconds.. When using [Number Inventory Cycles] this is a number such as 2, 4, 10, etc. . Note: when using a long dwell time per antenna, this will result in reduced reads for fast moving tags through the RF field.  A recommended starting point is to use (4) Inventory cycles per antenna and then adjust from there.